Command List - Sony PDW-HD1500 Operation Manual

To log in
If this unit is connected to a remote computer with a FAM
connection, first exit file operations on the FAM
connection (see page 81).
1
Load a disc into this unit and put the unit into the
following state.
• Recording, playback, search and other disc
operations (see page 44): Stopped
• THUMBNAIL button (see page 15): Off
• Disc access by Lock or Delete All Clips, Format
Disc, and so on in the Disc Menu (see page 57):
Stopped
Note
Login is not possible unless a disc is loaded and the
unit is in the state described above.
2
Start the command prompt.
3
Enter "ftp <SP> <IP address>", and press the Enter
key. (<SP> refers to a space.)
For example, if the IP address of this unit is set to
"192.168.001.010", enter "ftp 192.168.1.10".
Refer to the Windows help for more information about
the FTP command.
If the connection succeeds, you are prompted to enter
a user name.
4
Enter the user name "admin" and press the Enter key.
When the user name is verified, you are prompted to
enter a password.
5
Enter the password and press the Enter key.
The password is set to "pdw-hd1500" when the unit is
shipped from the factory.
The login is complete when the password is verified.
See page 84 for the FTP protocol commands
supported by this unit.
If the connection times out
This unit terminates FTP connections if no command
is received within 90 seconds of the last command. If
this occurs, log out (see the next section) and repeat
steps 2 to 4.
Note
If you power this unit off during an FTP connection,
the data transferred thus far is discarded.
84
FTP File Operations
To log out
To log out after finishing file operations, enter "QUIT" at
the command prompt and press the Enter key.

Command list

The FTP protocol commands supported by this unit
include standard commands (see the next section) and
extended commands (see page 87).
Notes
• To execute FTP commands, you must install application
software such as PDZ-1 on your computer.
• The commands supported by application software vary.
• In the command syntax, <SP> means a space, entered by
pressing the space bar, and <CRLF> means a new line,
entered by pressing the Enter key.
Standard commands
USER
Send this command to begin the login process.
Command syntax: USER <SP> <user name> <CRLF>
Input example: USER admin
PASS
After sending the USER command, send this command to
complete the login process.
Command syntax: PASS <SP> <password> <CRLF>
Input example: PASS pdw-hd1500
QUIT
Terminates the FTP connection. If a file is being
transferred, terminates after completion of the transfer.
Command syntax: QUIT <CRLF>
PORT
Specifies the IP address and port to which this unit should
connect for the next file transfer (for data transfer from this
unit).
Command syntax: PORT <SP> <h1,h2,h3,h4,p1,p2>
<CRLF>
• h1 (most significant byte) to h4 (least significant byte): IP
address
• p1 (most significant byte), p2 (least significant byte): Port
address
Input example: PORT 10,0,0,1,242,48
(IP address: 10.0.0.1, Port number: 62000)