Sony PDW-HD1500 Operation Manual page 122

Alarm message in time
data display area
REF NON-STD
a) Displayed only when setup menu item 016 ALARM DISPLAY is set to
"on".
Alarms relating to sensors and drives
Alarm message in time
data display area
FAN Stopped
DR-FAN Stop
N-FAN Stop
High TEMP!
HUMID!
BATT EMPTY!
Unknown USB
Alarms related to system frequency
Alarm message in time
data display area
1080/59.94i
1080/50i
122
Troubleshooting
Alarm message in video monitor screen Action
A NON-STANDARD REF SIGNAL IS
BEING USED FOR REF VIDEO. USE A
STANDARD SIGNAL.
Alarm message in video monitor acreen Description/action
FAN MOTOR STOPPED.
DRIVE FAN MOTOR STOPPED.
FAN MOTOR ON NET-4 BOARD
STOPPED.
HIGH TEMPERATURE.
HIGH TEMPERATURE IN DRIVE.
HIGH TEMPERATURE ON NET-4 BOARD.
MOISTURE HAS BEEN DETECTED.
BATTERY EMPTY!
UNKNOWN USB DEVICE.
Alarm message in video monitor screen Action
RECORDING AND PLAYBACK IS NOT
POSSIBLE.SYSTEM FREQUENCY
SELECTION DIFFER FROM IT ON DISC.
Input a standard signal.
Contact a Sony service representative.
Note
The unit will not stop operating, but if you continue to
use it in this state temperatures inside the unit or the
drive will rise, possibly resulting in failure or fire.
Stop recording or playback, power the unit off and on
again, and wait until the HUMID display disappears.
Change the battery.
The USB connector of this unit is for maintenance
purposes only. Do not connect a USB device for any
purpose other than maintenance.
This appears when the system frequency selection of
the unit differs from that of the loaded disc.Insert a
disc with the same system frequency as the unit, or
change the unit's system frequency.