Table of Contents
Advertisement
For other OS systems
We use MS-DOS as an example to show how to use the board under
other operation systems, in addition of the Windows OS.
Refer the MS-DOS programs in the attached FD.
For a PCI bus board, the system will automatically assign usable
resources to the board. Refer the following procedure to confirm
the assigned resources.
Procedure
(1) Set the board ID.
(2) Be sure that the personal computer is off; then plug the board
into a PCI bus slot in the personal computer.
(3) Turn the personal computer ON to start up MS-DOS.
(4) Copy the programs that are under the DOS directory of the
attached FD to a directory of your HDD.
(5) Execute the CNTPCI.EXE resource confirmation program.
(6) Check the I/O addresses and interrupt level (IRQ) displayed on
the screen.
Note!
When you use the board under a non plug-and-play OS like MS-
DOS, be sure that [PnP OS] is either [disabled] or set to [not to
use] in the PC's BIOS setup. If this is set to [Windows 95], for
example, the board might not be recognized properly.
CNT24-4D(PCI)
Board Setup
19
Advertisement
Table of Contents
