For Other Os Systems - Contec COM-2(PCI) User Manual

Board Setup

For Other OS Systems

For all the other operation systems, in addition of the Windows OS,
we use MS-DOS/Windows 3.1 as an example to show how to use
the board under the OS.
For all the other operation systems, refer the MS-DOS programs of
the attached FD as an example.
For a PCI bus board, the system will automatically assign a usable
resource/resources to the board. Refer the following procedure to
copy the attached programs and to confirm the assigned
resource/resources.
Hardware Installation Steps
(1) Set the board ID.
(2) Be sure that the personal computer is off; then plug the board
(3) Turn the personal computer ON to start up MS-DOS.
(4) Run the resource checking program (COMPCI.EXE) from the
(5) Check the I/O address and interrupt level displayed on the
Obtaining resource information
You can obtain the PC resource information assigned to the board
by accessing the PCI BIOS. For specific details, refer to the
sample programs in the DOS directory of the supplied FD.
32
into a PCI bus slot in the personal computer.
DOS directory of the supplied floppy disk.
screen. If the I/O address and interrupt level are displayed
correctly, the board can be used on MS-DOS and
Windows 3.1.
COM-2(PCI), COM-4(PCI), COM-8(PCI)