Setup Menu: Options - ResMed Stellar 150 Clinical Manual

Setup menu: Options

The optional device settings are available from the Options menu and its Configuration
submenu.
Parameter
Learn Circuit
FiO
Sensor
2
1
Calibration
SmartStart/
Stop
1
Ramp Time
Start CPAP
42
Default Description
1
- 1. If in use, turn off the oxygen flow.
2. Select the mask type.
3. Set up the air circuit including accessories and patient interface.
Note: For invasive use, do not connect a catheter mount,
tracheostomy tube or HMEF).
4. Leave the air circuit unobstructed and open to the air.
5. Press
6. Wait for the device to complete its automated tests (<30 sec).
The results are displayed when complete.
If the circuit configuration has been successfully learnt,
displays. If unsuccessful,
page 57).
- The device starts the calibration of the FiO
measure the oxygen concentration of the breathable air.
1. Press
2. Wait for the device to complete its calibration.
The results are displayed when complete.
Note: Turn off the oxygen flow.
Off If enabled, the device will start automatically when the patient
breathes into the patient interface and will stop automatically
(SmartStop) when the mask is taken off. This means the Start/Stop
key does not have to be pressed to begin/end treatment.
Note: The SmartStop feature is disabled if:
Full face or Trach is selected as mask option
•
High leak or Low minute ventilation alarms are set to ON
•
Mask fit operation is proceeding
•
Confirm therapy stop option is enabled.
•
Options: On, Off
Off If Max Ramp Time has been set, the patient may select any value up
to this time.
Options: 0 min-Max Ramp Time (max 45 minutes, 5 minutes
increments)
4.0 cm H O Sets the pressure at the beginning of the Ramp Time in CPAP
2
mode.
Options: 4 cm H
to start the Learn Circuit.
displays (see "Troubleshooting" on
to start the FiO sensor calibration.
2
O–CPAP , 0.2 cm H
2 2
monitoring sensor to
2
O increments