Aiwa CX-ZR774 Operating Instructions Manual page 23

2,4
The unit can be turned on at a specified time every day with the
built-in timer.
Preparation
Make sure the clock is set correctly.
1 Press TIMER to display @, then press ENTER
within 6 seconds.
@
is displayed, and the hour flashes.
o
2
3
4
If you press
ENTER
after 6 seconds, another operation may
start.
Designate the hour of the timer-on time by turning
MULTI JOG, then press ENTER. Repeat to
designate the minute of the timer-on time.
After you designate the timer-on time, one of the source
names flashes on the display.
Press one of the function buttons to select a
source, then press ENTER.
The selected source name flashes. At this time, the selected
function button does not light up in red.
If TUNER is pressed, the band cannot be selected in this
step.
Select the duration for the timer-activated period
with MULTI JOG.
5
6
a
Prepare the source.
To
listen to a CD,
load the disc to be played first on tray 1.
;,
To
listen to a tape,
insert the tape into Deck 1 or 2.
To listen to the radio,
tune in to a station.
;$$
!*;:
Press POWER to turn the unit off after adjusting #:$
the volume and tone.
;~;
8
@
remains on the display after the power is turned off (timer '" "
standby mode).
G
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automatically set to 20 when the power
is turned off with the volume level set to 21 or more.
To
check the specified time and source
Press TIMER. The timer-on time and the selected source name
with the duration for the timer-activated period are displayed
alternately for 6 seconds,
To cancel timer standby mode temporarily
Press TIMER repeatedly until "@OFF" appears on the display.
To restore the timer standby mode, press TIMER once or twice
to display 0 or OREC.
Using the unit while the timer is set
You can use the unit normally after setting the timer.
Before turning off the power, repeat step 5 to prepare the source,
and adjust the volume and ton-e.
Timer playback and timer recording will not begin unless the
power is turned off.
Connected equipment cannot be turned on and off by the built-
in timer of this unit. Use an external timer.
During operation, + and - are also available instead of
MULTI JOG.
During operation, II SET is also available instead of ENTER.
Timer recording is applicable for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press TIMER repeatedly until @REC appears on the
display, then press ENTER within 6 seconds.
Carry out the steps of "SETTING THE TIMER" from step 2 and
insert the tape to be recorded on into Deck 2 after step 5.
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
ENGLISH
23