Aiwa CX-ZR774 Operating Instructions Manual page 16

This section explains how to record from the tuner, CD player, or
Preparation
Set the tape to the point where recording will start.
Use Type I (normal) tape only.
Note that recording will be done on one side of the tape only.
7 Insert the tape to be recorded on into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
2
3
A
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD,
press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from the connected source, press PHONO or
VIDEO/AUX and play.
Press REC/REC MUTE to start recording.
To stop recording, press .
To pause recording, press 11. (Applicable
when the recording
source is TUNER, PHONO or Vi DEO/AUX. ) To resume
recording, press again.
To start recording with the remote control
First press @/OREC/REC MUTE, and then press +F within 2
seconds.
The output volume and tone of the speakers or headphones
may be freely varied without affecting the recording.
4-second blank spaces can be inserted at the desired point during
recording. (Applicable when the source is TUNER, PHONO or
VIDEO/AUX.)
1
Press REC[REC MUTE during recording or while in
recording pause mode.
~
on the display flashes for 4 seconds and a 4-second
blank space is made. Then, the deck enters the recording
pause mode.
2
Press II to resume recording.
To insert a blank space of less than 4 seconds,
press REC/
REC MUTE again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after
the
deck enters recording pause mode, press REC/REC MUTE
again. Each time the button is pressed, a 4-second blank space
is added.
When the selected function is CD, playback and recording
start simultaneously.
To erase a recording
Make sure the microphone is not connected to the unit.
Set the microphone volume to OFF (page 20).
1 Insert the tape to be erased into Deck 2 and press TAPE/
DECK 1/2 to display '(TP 2.
2 Set the tape to the point where the erasure is to be started.
3 Press
REC/REC MUTE to start the erasure.
16
ENGLISH