Aiwa CX-ZR774 Operating Instructions Manual page 18

4,5
2
u,-
The Al edit recording function enables CD recording without
worrying about tape length and track length. When a CD is
inserted, the unit automatically calculates the total track lengths.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Al: Artificial Intelligence)
m
The Al edit recording will not start from a point halfway into the
tape. The tape must be recorded from the beginning of either
side.
Use the remote control from steps 3 to 8.
1
2
3
4
5
Tape length
Tape side A Selected
(front side)
tracks for side A
6 Press
./0
REC/REC MUTE, then press <E
within 2 seconds to start recording on the first
side.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
Deck 2 enters the recording stop mode. After entering the
recording mode, go to step 7.
7 Press EDIT/CHECK to display the program for the
second
recording and turn over the tape in Deck 2.
"0
is displayed.
8 Press
./0
REC/REC MUTE, then press <~
within 2 seconds to start recording on the second
side.
To
stop recording
Press W. Recording and CD play stop simultaneously.
To clear the edit program
Press twice so that "EDIT" disappears on the display.
To check the order of the programmed track numbers
Before recording, press
EDIT/CHECK to select side A or B, and
press + or - repeatedly.
Tape side
Program number
Track number
Programmed track numbers
To
add tracks from other discs to the edit program
if there is any time remaining on the tape after step 5 on page
16, you can add tracks from other discs in the CD compartment.
1
2
3
4
5
Press
EDIT/CHECK to select side A or B.
Press
DIRECT, then
press one of the numbered buttons 1-5
within 3 seconds to select a disc.
Press the numbered buttons O-9 and +1 O to select the tracks.
A track whose playing time is longer than the remaining time
cannot be programmed.
Repeat steps 2 and 3 to add more tracks.
Start recording.
Time on cassette tapes and editing time
The actual cassette recording time is usually a little longer than
the specified recording time printed on the label. This unit can
program tracks to use the extra time. When the total recording
time is a little longer than the tape's specified recording time
after editing, the display shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
Recording is inhibited if the erasure presentation tab for the
side of the tape facing out from the unit is broken off.
The Al edit function cannot be used with discs containing 31
tracks or more.
Remaining time of side A
18
ENGLISH