Aiwa CX-ZR774 Operating Instructions Manual page 19

4,5
2
*,W
In the Programmed edit recording function, the tracks can be
programmed while checking the remaining time on each side of
the tape as the tracks are programmed.
The programmed edit recording will not start from a point halfway
in the tape. The tape must be recorded on from the beginning of
either side.
Use the remote control from steps 3 to 10.
1
2
3
4
5
Insert the tape into Deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
Press CD and load the disc(s).
Press EDl"r/CHECK twice.
"PFIGM EDIT" and "PRGM" light up on the display.
PRGM
PRGM EDIT
When "Al" is displayed, press
EDIT/CHECK again.
lPress the numbered buttons O-9 to designate the
Itape length.
"1 O to 99 minutes can be specified.
Maximum recording
Tape length
Tape side(A)
time for side A
~
Press DIRECT, then press one of the numbered
buttons 1-5 within 3 seconds to select a disc,
Then, press the numbered buttons O-9 and +10
to program a track.
Exarnp/e.' To select the 10th track of disc 2, press
DIRECT
and
2.
then +10 and O.
Selected track number
Programmed track numbers
7
8
9
Press EDIT/CHECK to select side B and program
the tracks for side B.
After confirming B on the display, repeat step 5.
Tape side B(reverse side)
Press EDIT/CHECK to select side A. Then press
./OREC/REC MUTE and press <~ within 2
seconds to start recording.
The tape is rewound to the beginning of the front side, the
lead segment is played through for 10 seconds, and recording
starts. When the last track programmed for side A is finished,
Deck 2 enters the recording stop mode. After entering the
recording mode, go to step 9.
Press EDIT/CHECK to display the program for the
second recording and turn over the tape in Deck 2,
"!3" is displayed.
10 Press /0 REC/REC MUTE, then press +>
within 2 seconds to start recording on the second
side.
To stop recording
Press . Recording and CD play stop simultaneously.
To check the order of the programmed track numbers
Before recording, press
EDIT/CHECK to select side A or B, and
press + or > repeatedly.
Disc number
Program number
Track number Programmed track numbers
To change the program of each side
Press
EDIT/CHECK
to select side A or B, and press CLEAR
to clear the program on the selected side. Then program tracks
again.
To clear the edit program
Press CLEAR twice so that
"EDl~ disappears on the display.
Recording is inhibited if the erasure presentation tab for the
side of the tape facing out from the unit is broken off.
Up to 30 tracks can be programmed from any of the inserted
discs.
ENGLISH 19