About The Battery; Installing The Standard Mount; Installing The Out-Front Mount; Releasing The Edge - Garmin EDGE 830 Owner's Manual

2
Plug the small end of the USB cable into the USB port on the
device.
3
Plug the large end of the USB cable into an AC adapter or a
computer USB port.
4
Plug the AC adapter into a standard wall outlet.
When you connect the device to a power source, the device
turns on.
5
Charge the device completely.
After you charge the device, close the weather cap.

About the Battery

This device contains a lithium-ion battery. See the Important
Safety and Product Information guide in the product box for
product warnings and other important information.

Installing the Standard Mount

For the best GPS reception, position the bike mount so the front
of the device is oriented toward the sky. You can install the bike
mount on the stem or the handlebars.
1 Select a secure location to mount the device where it does
not interfere with the safe operation of your bike.
2 Place the rubber disk
Two rubber disks are included, and you can select the disk
that best fits your bike. The rubber tabs align with the back of
the bike mount so it stays in place.
3
Place the bike mount on the bike stem.
4
Attach the bike mount securely using the two bands
5
Align the tabs on the back of the device with the bike mount
notches .
6
Press down slightly and turn the device clockwise until it
locks into place.
2
WARNING
on the back of the bike mount.

Installing the Out-Front Mount

NOTE: If you do not have this mount, you can skip this task.
1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2
Use the hex key to remove the screw
connector
3
Place the rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
4
Place the handlebar connector around the rubber pad.
5
Replace and tighten the screw.
NOTE: Garmin
mount is secure, with a maximum torque specification of
7 lbf-in. (0.8 N-m). You should check the tightness of the
screw periodically.
6 Align the tabs on the back of the Edge device with the bike
mount notches
7
Press down slightly and turn the Edge device clockwise until
it locks into place.

Releasing the Edge

1 Turn the Edge clockwise to unlock the device.
2 Lift the Edge off the mount.
.

Installing the Mountain Bike Mount

NOTE: If you do not have this mount, you can skip this task.
1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2
Use the 3 mm hex key to remove the screw
handlebar connector
.
® recommends tightening the screw so the
.
.
from the handlebar
from the
Introduction