Introduction; Getting Started; Charging The Device; About The Battery - Garmin EDGE 810 Owner's Manual

Introduction

See the Important Safety and Product Information guide in the
product box for product warnings and other important
information.
Always consult your physician before you begin or modify any
exercise program.

Getting Started

When using your device the first time, you should complete
these tasks to set up the device and learn about the basic
features.
1
Charge the device (Charging the Device, page
2
Install your device using the standard mount
Standard Mount, page
the Out-Front Mount, page
3 Turn on the device (Turning On the Device, page
4 Locate satellites (Acquiring Satellite Signals, page
5 Go for a ride (Going for a Ride, page
6 Register the device (Registering Your Device, page
7
Upload your ride to Garmin Connect
Garmin Connect, page

Charging the Device

To prevent corrosion, thoroughly dry the USB port, the weather
cap, and the surrounding area before charging or connecting to
a computer.
The device is powered by a built-in lithium-ion battery that you
can charge using a standard wall outlet or a USB port on your
computer.
NOTE: The device will not charge when outside the temperature
range of 32° to 113°F (0° to 45°C).
1
Pull up the weather cap
2
Plug the small end of the USB cable into the mini-USB port.
3
Plug the USB end of the cable into the AC adapter or a
computer USB port.
4
Plug the AC adapter into a standard wall outlet.
When you connect the device to a power source, the device
turns on.
5
Charge the device completely.
A fully charged battery can run for up to 15 hours before it must
be recharged.

About the Battery

This device contains a lithium-ion battery. See the Important
Safety and Product Information guide in the product box for
product warnings and other important information.
Introduction
WARNING
1).
(Installing the
1) or the out-front mount (Installing
1).
3).
(Sending Your Ride to
™
9).
NOTICE
from the mini-USB port
WARNING

Installing the Standard Mount

For the best GPS reception, position the bike mount so the front
of the device is oriented toward the sky. You can install the bike
mount on the stem or the handlebars.
1
Select a secure location to mount the device where it does
not interfere with the safe operation of your bike.
2
Place the rubber disk
The rubber tabs align with the back of the bike mount so it
stays in place.
2).
2).
3
Place the bike mount on the bike stem.
17).
4
Attach the bike mount securely using the two bands
5
Align the tabs on the back of the device with the bike mount
notches
6
Press down slightly and turn the device clockwise until it
locks into place.
.

Installing the Out-Front Mount

1
Select a secure location to mount the Edge device where it
does not interfere with the safe operation of your bike.
2
Use the hex key to remove the screw
connector
3
If necessary, remove the two screws on the back side of the
mount
change the orientation of the mount.
4
Place the rubber pad around the handlebar:
• If the handlebar diameter is 25.4 mm, use the thicker pad.
• If the handlebar diameter is 31.8 mm, use the thinner pad.
5
Place the handlebar connector around the rubber pad.
6
Replace and tighten the screw.
NOTE: Garmin
in. (0.8 N-m). You should check the tightness of the screw
periodically.
on the back of the bike mount.
.
.
, rotate the connector , and replace the screws to
recommends a torque specification of 7 lbf-
®
.
from the handlebar
1