Http://Docs.fortinet.com - Fortinet FortiMail-100 Install Manual

FortiMail-5001A hardware installation
FortiMail™ Secure Messaging PlatformVersion 4.0 Patch 1Install Guide
Revision 2

http://docs.fortinet.com/

• Feedback
It is important to carefully seat the FortiMail board all the way into the chassis, to not use
too much force on the handles, and to make sure that the handles are properly locked.
Only then will the FortiMail board power-on and start up correctly.
FortiMail boards are hot swappable. The procedure for inserting a FortiMail board into a
chassis slot is the same whether or not the chassis is powered on.
To insert a FortiMail board into a chassis slot
To complete this procedure, you need:
• A FortiMail board with either the correct AMC slot filler panel or a FortiGate AMC
module installed in the front panel AMC opening
• An ATCA chassis with an empty slot
• An electrostatic discharge (ESD) preventive wrist strap with connection cord
Caution: FortiMail boards must be protected from static discharge and physical shock.
Only handle or work with FortiMail boards at a static-free workstation. Always wear a
grounded electrostatic discharge (ESD) preventive wrist strap when handling FortiMail
boards.
Caution: Do not carry the FortiMail board by holding the handles or retention screws.
When inserting or removing the FortiMail board from a chassis slot, handle the board by the
front panel. The handles are not designed for carrying the board. If the handles become
bent or damaged the FortiMail board may not align correctly in the chassis slot.
1 Attach the ESD wrist strap to your wrist and to an available ESD socket or wrist strap
terminal.
2 If required, remove the protective metal frame that the FortiMail board has been
shipped in.
3 Insert the FortiMail board into the empty slot in the chassis.
4 Unlock the handles by squeezing the handle locks.
Unlock
Handle
5 Open the handles to their fully open positions.
Caution: To avoid damaging the lock, make sure you squeeze the handles fully to unlock
them before opening. The handles should pop easily out of the board front panel.
Inserting a FortiMail board
57