Siemens S120 Instructions Manual page 53

Figure 34 – Windows: TCP / IP connection network card
Remember that, in order to do not have a reference duplicate IP, the last two digits identifying two
communication systems, must be different! So, the values for the inverter and the network card of the PC,
cannot be the same!
If in the supply the remote assistance pack (optional) is included, the values corresponding to the
configuration established by Omarlift for the inverter are different, and they assume a configuration of
this type:
IP: 192.168.33.xx
Subnet mask: 255.255.255.0
The definitive value will be supplied by Omarlift, jointly with the optional pack
In the case of a full reset of the system, the address could be automatically set to the SIEMENS values
5. Start the SIEMENS STARTER program, then proceed as follows:
a. If the Software and parameters on the inverter has already been loaded and saved on your PC,
bring up the saved copy via Project> Open, choose the location where it was saved and go to step
described in the paragraph 8.4.1; otherwise
b. If the parameters on software and have never been loaded and saved on the PC (first time):
create a new project by choosing Project> New, and giving it a name that allows to recognize (eg: plant
name + date). Then select Tools> PG / PC interface to select the parameter setting interface and
choose the ID number of the TCP / IP where is connected the Ethernet cable, which was previously
configured in Network resources (in our example the Intel (R) 82759LM Gigabit Network Connection
TCP / IP).
Siemens S120_EN_rev06-08062017.docx
(Network card for the last two digits must be set different,)
8-5