Antenna Gyro Assembly; Figure 4-5 Rf Cable Ferrules; New Rf Board Installation; Figure - KVH Industries TracVision 6 Technical Manual

TracVision 6 Installation and Technical Manual
RF Cable Ferrules
Ferrules

New RF Board Installation

Failure to hold the ferrules tightly
while loosening the RF connectors
can result in damage to the cables
and reduce the signal quality.
4-6
3. Remove the two RF cables from the RF connectors

Figure 4-5

with a
while loosening the connectors to avoid excess
stress on or twisting of the cables. Refer to Figure
4-6.
4. Remove the four 6-32 x
5. Remove the RF Board and discard.
6. Install the new RF Board, making certain to align
the Board so that the RF Connectors are facing the
bottom. Figure 4-6 illustrates the alignment of the
new RF Board and cables.
Figure 4-6
7. Secure the RF board using the screws removed in
Step 4.
8. Reattach the RF cables, making certain that the RF
cable originally attached to the top RF connector
on the old RF Board is connected to the top RF
connector on the new RF Board.
9. Attach the Data and RF Flash cables to the
RF Board.
4.5
1. Remove the printed circuit board (PCB) cover,
illustrated in Figure 4-2, using a #2 Phillips
screwdriver and a
2. Use the screwdriver to remove the four screws and
the counterweight.
⁄ " wrench. Hold the RF connector ferrule
7
1 6
3
Data Cable

Antenna Gyro Assembly

3 ⁄ " nut driver/socket.
8
⁄ " screws and set aside.
8
Flash Cable