KVH Industries TracVision 6 Technical Manual page 6

TracVision 6 Technical
Manual Addendum
(ECO #s 5965, 5959, 5503, 5315)
The following changes have been made to Revision B of the
TracVision 6 Installation and Technical Manual (KVH Part
Number 54-0166).
3.1.1 Blown Fuse, Low Power, or Wiring
The 4-amp fuse on the CPU Printed Circuit Board (PCB)
replaced with two 3.15-amp fuses to better protect the Antenna Unit's
electronics.
1. Blown Fuse – The Antenna Unit is equipped with
two fuses mounted on its CPU Board. If either of
these fuses has blown or been broken, the
Antenna Unit will not operate. Refer to Section 4.4,
"PCB Removal and Replacement," for details on the
fuse locations and how to access the CPU Board.
4.3 TracVision 6 Field
Replaceable Units
Table 4-1 has been updated to show the new part number for the
3.15-amp fuses and the new part number for the RF Detector PCB. The
azimuth limit switch has also been added to the list.
FRU
Radome
CPU
RF Detector PCB
Antenna Gyro Sensor
Antenna Gyro Gasket
Elevation Drive Belt
Elevation Motor
Azimuth Limit Switch Assembly
European LNB Assembly
54-0166 Addendum to Rev. B
TracVision 6 Installation and Technical Manual – ADDENDUM
has been
Part Number
02-1047-01
02-0992
02-1233
02-1035
24-0139
24-0105-83
02-1050
02-0957-01
02-0932
Table 4-1
TracVision 6 Field
Replaceable Units
1