KVH Industries TracVision 6 Technical Manual page 30

TracVision 6 Installation and Technical Manual
Antenna Unit Dimensions
Baseplate/Foam Seal Orientation
(Bottom View)
2-4
Figure 2-1
27.36"
(695 mm)
Compression Seal
4x .50"
(4x 13 mm)
Figure 2-2
2. Drill four
3" (80 mm) diameter circle in the center of the
pattern and cut out to make a passage for the
cables to connect to the baseplate. Smooth the
edges of the hole to protect the cables.
3. Place the foam seal in position on the mounting
surface with the hole centered over the cable
.9,
access cutout and the paper backing on the bottom
as shown in Figure 2-2. Do not remove the paper
backing at this time. Scribe a line all around the
seal.
26.2"
(665 mm)
6.0" (152 mm)
12.0"
(305 mm)
1 ⁄ " (13 mm) bolt holes. Mark a
2
6.0" (152 mm)
12.0"
(305 mm)
FWD