KVH Industries TracVision 6 Technical Manual page 80

TracVision 6 Installation and Technical Manual
Tracking and Conical
Scan Commands
F-4
Idle Mode
Function:
Command:
Argument:
Response:
Current Cable Wrap Angle
Function:
Command:
Argument:
Response:
F.4
Table F-4 Target Location
Function:
Command:
Argument:
Response:
Analog Signal Strength Report
Function:
Command:
Argument:
Response:
halts active tracking and conical scan, then enters
idle mode
HALT
none
echoes the command
sets or reports current cable wrap angle, defined as
0° (CCW limit) to 700° (CW limit); the value is
expressed as 0000-7000 with an implied decimal
WRAPANGLE,xxxx
the desired cable wrap angle setting
Wrap Angle = xxxx
Tracking and Conical
Scan Commands
reports the target location in antenna frame. Data
format is E### for elevation in degrees 000-900 and
A#### for azimuth in degrees 0000-3599 with
implied decimals
TGTLOCATION
none
Target Location = A = E###, A####
reports signal strength from RF detector circuit in
A/D counts (000-FFF Hex)
SIGLEVEL
none
Signal Strength = xxxx
B = E###, A####