Rear Differential Front Member - Subaru LEGACY 2006 Manual

asieps_tobira.book 77 ページ ２００９年１０月２６日 月曜日 午前９時１６分
8. Rear Differential Front Mem-
ber
A: REMOVAL
1) Disconnect the ground cable from battery.
2) Jack-up the vehicle.
3) Support the rear differential using transmission
jack, and then remove the rear differential front
member.
(A)
(A) Rear differential front member
B: INSTALLATION
Using new self-locking nuts, install the rear differ-
ential front member.
Tightening torque:
T1: 65 N·m (6.6 kgf-m, 48 ft-lb)
T2: 110 N·m (11.2 kgf-m, 81 ft-lb)
T1
C: INSPECTION
1) Check the rear differential front member for
damage, bend and corrosion.
If damage, bend or corrosion is excessive, replace
the rear differential front member.
2) Check the bushings of rear differential member
for cracking, hardening and damage.
If cracking, hardening or damage is excessive, re-
place rear differential front member.

Rear Differential Front Member

DI-00293
T2
DI-00294
DI-77
DIFFERENTIALS