Digital Output Module Et 200C; Do 8 Dc 24V/0.5A (6Es7 142-0Bf00-0Xb0) - Siemens SIMATIC ET 200C Manual

ET 200C Components
3.2 Digital Output Module ET 200C; DO 8
(6ES7 142-0BF00-0XB0)
Characteristics
The digital output module ET 200C; DO 8
ing characteristics:
3-4
Degree of protection IP 66/IP 67 (see Installation rules, Section 4.1)
Output current per channel: 0.5 A
Choice of nine different baud rates:
9.6, 19.2; 93.75; 187.5; 500; 1500; 3000; 6000 and 12000 kbaud
The baud rates 3000, 6000 and 12000 kbaud can only be used if the
module is operated with the IM 308-C (see Section 1.2).
Channel-by-channel diagnostics of the outputs for wire break and
short-circuit/overload and load voltage of the outputs (can be switched off
with COM ET 200, see Section 5.1.4).
The diagnostics can be output via the IM 308-B master interface module.
In addition, each diagnostic message causes the LED "DIA" or the
respective individual diagnostics LED to light up.
LEDs for
– RUN
– BF (bus fault)
– DIA (diagnostics of the outputs)
– U (load voltage supply of the outputs)
L
– Status of the outputs or individual diagnostics
Attachment of the module without opening the cover (drill-hole template
at the back of the manual)
DC 24V/0.5A
DC 24V/0.5A has the follow-
ET 200C Distributed I/O Station
EWA 4NEB 812 6119-02b