Table of Contents
Advertisement
GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for
the owner and operators of a JET JWBS-9X band saw to promote safety during installation, operation and maintenance procedures.
Please read and understand the information contained in these operating instructions and the accompanying documents. To obtain
maximum life and efficiency from your machine, and to use the machine safely, read this manual thoroughly and follow instructions
carefully.
...Table of Contents
Contents of delivery
description
Folding the bandsaw blade
Mitre gauge setup
machine table
8. Maintenance and inspection
9. Troubleshooting
10. Environmental protection
11. Available accessories
12. „safe operation"................. appendix A
1. Declaration of conformity
On our own responsibility we hereby
declare that this product complies with
the regulations* listed on page 2.
Designed in consideration with the
standards**. CE type examination***
performed by****.
2. Warranty
JPW (Tool) AG guarantees that the
supplied product(s) is/are free from
material defects and manufacturing faults.
This warranty does not cover any defects
which are caused, either directly or
indirectly, by incorrect use, carelessness,
damage due to accidents, repairs or
inadequate maintenance or cleaning as
well as normal wear and tear.
Machine
Further details on warranty (e.g. warranty
period) can be found in the General Terms
and Conditions (GTC) that are an
integral part of the contract.
These GTC may be viewed on the website
of your dealer or sent to you upon
request.
JPW (Tool) AG reserves the right to make
changes to the product and accessories at
any time.
3. Safety
Tilting of
3.1 Authorized use
This machine is designed for sawing wood,
wood derived materials as well as similar
to be machined hard plastics only.
Machining of other materials is not
permitted and may be carried out in
specific cases only after consulting with
the manufacturer.
No metal workpieces may be machined.
The workpiece must allow to safely be
loaded, supported and guided.
The proper use also includes compliance
with the operating and maintenance
instructions given in this manual.
The machine must be operated only by
persons familiar with its operation and
maintenance and who are familiar with its
hazards.
The required minimum age must be
observed
3
The machine must only be used in a
technically perfect condition
When working on the machine, all safety
mechanisms and covers must be
mounted.
In addition to the safety requirements
contained in these operating instructions
and your country's applicable regulations,
you should observe the generally
recognized technical rules concerning the
operation of woodworking machines.
Any other use exceeds authorization.
In the event of unauthorized use of the
machine, the manufacturer renounces all
liability and the responsibility is
transferred exclusively to the operator.
3.2 General safety notes
Woodworking machines can be dangerous
if not used properly. Therefore the
appropriate general technical rules as well
as the following notes must be observed.
Read and understand the entire
instruction manual before attempting
assembly or operation.
Keep this operating instruction close by
the machine, protected from dirt and
humidity, and pass it over to the new
owner if you part with the tool.
No changes to the machine may be made.
Daily inspect the function and existence of
the safety appliances before you start the
machine.
Do not attempt operation in this case,
protect the machine by unplugging the
mains cord.
Remove all loose clothing and confine
long hair.
Before operating the machine, remove tie,
rings, watches, other jewellery, and roll up
sleeves above the elbows.
Wear safety shoes; never wear leisure
shoes or sandals.
Advertisement
Table of Contents
