Related Manuals for Jet JWBS-9X
Summary of Contents for Jet JWBS-9X
- Page 1 JWBS-9X WOOD BAND SAW Original: Operating Instructions TOOL FRANCE SARL 9 Rue des Pyrénées, 91090 Lisses, France www.jettools.com M-10000860M 2019-03...
- Page 2 CE-Conformity Declaration CE-Konformitätserklärung Déclaration de Conformité CE Product / Produkt / Produit: Band saw / Bandsäge / Scie à ruban JWBS-9X Stock No. : 10000860M Brand / Marke / Marque: Manufacturer / Hersteller / Fabricant: TOOL FRANCE SARL 9 Rue des Pyrénées, 91090 Lisses, France We hereby declare that this product complies with the regulations Wir erklären hiermit, dass dieses Produkt der folgenden Richtlinie entspricht...
-
Page 3: Table Of Contents
Dear Customer, Many thanks for the confidence you have shown in us with the purchase of your new JET-machine. This manual has been prepared for the owner and operators of a JET JWBS-9X band saw to promote safety during installation, operation and maintenance procedures. -
Page 4: General Safety Notes
3.2 General safety notes Stay alert! Woodworking machines can be dangerous if not used properly. Give your work undivided attention. Use common sense. Therefore the appropriate general technical rules as well as the Keep an ergonomic body position. following notes must be observed. Maintain a balanced stance at all times. -
Page 5: Machine Specifications
The moving saw blade in the work area can cause injury. Additional support Operating manual Broken saw blades can cause injuries. Spare parts list Thrown workpieces can lead to injury 4.4 Machine description Wood chips and sawdust can be health hazards. Be sure to wear personal protection gear such as safety goggles ear- and dust protection. -
Page 6: Transport And Start Up
5. Transport and start up 5.1 Transport and installation For transport use a forklift or hand trolley. Make sure the machine does not tip or fall off during transport. The machine is designed to operate in closed rooms and must be placed stable on firm and levelled ground. -
Page 7: Mains Connection
- Set pointer at 0° to match the scale (T, Fig 7). The machine lamp starts automatically when the motor is turned on. - Re-install the table slot bolt and wing nut (Fig 5) The red OFF-button on the main switch stops the machine. Install the fence: - Raise the clamp on the fence assembly to the up position. -
Page 8: Setup And Adjustments
Fig 12.1: Performing high cuts Fig 12.5: Curved cuts Fig 12.6: Circular cutting Fig 12.2: Performing diagonal cuts 7. Setup and adjustments General note: Setup and adjustment work may only be carried out after the machine is protected against accidental starting by pulling the mains plug. -
Page 9: Blade Tracking Adjustment
Fig 15 - Proper tracking is achieved when driver and idler wheels are aligned. Tracking knob (K, Fig 13) is used to tilt upper wheel and align blade wheels. Fig 13 - If blade rides away from cabinet, turn knob clockwise. If blade Open the upper and lower blade guards (Fig 14) rides toward cabinet, turn knob counter clockwise. -
Page 10: Mitre Gauge Setup
Fig 19 Fig 16 Adjust in same manner as on upper blade guide. The guide pins may not touch the sawblade teeth. Adjust the guide pin assembly accordingly (Fig 17). 7.6 Mitre gauge setup Setup adjustments shall never be performed when the machine is running. -
Page 11: Troubleshooting
European Union. Unplug the machine from power source. 11. Available accessories Table insert: Refer to the JET-Pricelist Replace a worn table insert. for various saw blades. The table insert must be made out of cutable material (e.g. wood, plastic, aluminium) The table insert may not project above table surface.