Siemens Sinumerik 840D sl Diagnostic Manual page 48

Overview of Alarms
NCK alarms
4334 [Channel %1: ] The amount of fine correction in parameter %2 of the
orientable toolholder %3 is too large
Parameters: %1 = Channel number
%2 = Invalid parameter of the orientable toolholder
%3 = Number of the orientable toolholder
Definitions: The maximum permissible value of the fine correction in an orientable toolholder is limited by the
MD20188 $MC_TOCARR_FINE_LIM_LIN for linear variables, and by the machine data MD20190
$MC_TOCARR_FINE_LIM_ROT for rotary variables. The alarm can only occur if the SD42974
$SC_TOCARR_FINE_CORRECTION is not equal to zero.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid fine correction value.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4336 [Channel %1: ] Orientable toolholder no. %2 for orientation
transformation %3 does not exist
Parameters: %1 = Channel number
%2 = Number of the orientable toolholder
%3 = Number of the orientation transformation that is to be parameterized with the orientable tool-
holder
Definitions: The orientable toolholder, with whose data the orientation transformation is to be parameterized (see
MD2.... $MC_TRAFO5_TCARR_NO_...), does not exist.
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid tool-carrier number.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4338 [Channel %1: ] Invalid transformation type '%2' in toolholder %3 for
orientation transformer %4
Parameters: %1 = Channel number
%2 = Transformer type
%3 = Number of the orientable toolholder
%4 = Number of the orientation transformation that is to be parameterized with the orientable tool-
holder
Definitions: The parameters of the orientation transformation are taken over from the data of an orientable tool-
holder. This orientable toolholder contains an invalid transformation type. (Types T, P and M are per-
missible).
Reaction: Correction block is reorganized.
Interface signals are set.
Alarm display.
NC Stop on alarm at block end.
Remedy: Enter a valid transformation type.
Program Con- Clear alarm with the RESET key. Restart part program
tinuation:
4340 [Channel %1: ] Block %2 invalid transformation type in transformation
no. %3
Parameters: %1 = Channel number
%2 = Block number, label
%3 = Transformation number
2-48
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
© Siemens AG, 2009. All Rights Reserved
03/2009