Siemens Sinumerik 840D sl Diagnostic Manual page 559

03/2009
100015 Error in '%1' :%nlog file : %2
Parameters: %1 = --
%2 = --
Definitions: --
Remedy: --
100099 Additional value
Definitions: --
Remedy: --
100100 Record length %1 reached
Parameters: %1 = --
Definitions: --
Remedy: --
100101 No dynamic memory available
Definitions: --
Remedy: --
100102 Buffer limit for selection reached
Definitions: --
Remedy: --
100103 Area disabled for input
Definitions: --
Remedy: --
100104 Buffer is empty
Definitions: --
Remedy: --
100105 Search string '%1' not found
Parameters: %1 = --
Definitions: --
Remedy: --
100106 Error on saving
Definitions: This message will be displayed on editing a file (part program), if a memory operation could not be
performed correctly.
Reaction: Alarm display.
Remedy: If there is no memory space left in the NCK, it will not be possible to save anything. Other contents
(files, programs) must be deleted.
If the error occurs when the program is started immediately after the change, the changes will not
become effective. The program should be stopped immediately. The change must be repeated and
the program must be started after a small delay (approx. 1 sec.).
If the error occurs when a program is changed during execution, only a program reset will help.
100107 Error on opening %1
Parameters: %1 = --
Definitions: --
Remedy: --
100108 Write access not allowed in this state
Definitions: --
Remedy: --
100109 No block marked
Definitions: --
Remedy: --
© Siemens AG 2009 All Rights Reserved
SINUMERIK 840D sl, 840Di sl, SINAMICS, Diagnostics Manual (DAsl), 03/2009
Overview of Alarms
HMI-Alarms
2-559