Noise Emission; Dust Emission; Contents Of Delivery; Transport And Start Up - Jet JWBS-16X Operating Instructions Manual

Machine Table(Lx W)
Table tilting range
Working height
Dust port diameter
Overall (LxWxH)
Weight
Mains
Motor output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection
Mains
Motor output power
Reference current
Extension cord (H07RN-F):
Installation fuse protection

4.3 Noise emission

Determined according to EN 1807
(Inspection tolerance 4 dB)
Workpiece beech:
T=30mm, L=1500mm, moisture 8,5%
Acoustic power level
(according to EN ISO 3746):
Idling
Operating
Acoustic pressure level
(according to EN ISO 11202):
Idling
Operating
The specified values are emission levels and are not
necessarily to be seen as safe operating levels. Although
there is a correlation between emission and imission levels,
these do not constitute a basis for determining the necessity
of additional safety measures. Workplace conditions which
could influence the noise imission level include the duration
of resonance, spatial particulars, other noise sources etc. For
example, the number of machines and other work being
performed. The permissible workplace levels can vary from
country to country.
This information is intended to allow the user to make a better
estimation of the hazards and risks involved.

4.4 Dust emission

The band saw series JWBS-16X/18Q/20Q has been dust
emission inspected.
At an air velocity of 20 m/s on the dust port dia 100mm:
Vacuum pressure
Volume flow
The machine meets a workplace dust emission of 2 mg/m³.
530x530 mm
-10° to 45°
930mm
100mm
900x1100x1970mm
256 kg
230V ~1/N/PE 50Hz
1,5 kW (2HP) S1
9,5 A
3x1,5mm²
16A
400V ~3/PE 50Hz
2,2 kW (3 HP) S1
5 A
5x1,5mm²
16A
LwA 82 dB(A)
LwA 93 dB(A)
LpA 74 dB(A)
LpA 87 dB(A)
1250 Pa
565 m³/h
4.5 Content of delivery
Machine table
Fence
Fence support rails
Resaw guide
Mitre gauge
Assembly bag
Saw blade 20mm
Operating manual
Spare parts list

5. Transport and start up

5.1 Transport and installation

The machine will be delivered on an open crate.
For transport use a forklift or hand trolley. Make sure the
machine does not tip or fall off during transport.
The machine is designed to operate in closed rooms and
must be placed stable on firm and levelled ground.
The machine can be bolted down if required.
For packing reasons the machine is not completely
assembled.

5.2 Assembly

If you notice any transport damage while unpacking, notify
your supplier immediately. Do not operate the machine!
Dispose of the packing in an environmentally friendly manner.
Clean all rust protected surfaces with a mild solvent.
Attach the handle (A, Fig 2) to the hand wheel (B)
Mount the machine table to the trunions and attach the lock
knobs (A, Fig 3).
Fig 2