Advertisement
9.
Repeat steps 5 through 7 to program the remaining letters, numbers, or symbols of the
desired label. A total of six characters may be used in the creation of a label.
10. When you have programmed a label which is under 6 characters, press and hold in the
[F/W] key for one second to confirm the label (if the label is exactly 6 characters in length,
you do not need to press and hold in [F/W]).
11. When you have completed the creation of the label, press the PTT key to save the label
and return to the memory recall mode with labeled (alpha-numeric "Tag") display.
To disable the alpha-numeric Tag (enabling the frequency display):
1.
Set the VX-120/170 to the "MR" (Memory Recall) mode, and recall the memory channel
on which you wish to disable the alpha-numeric Tag.
2.
Press the [F/W] key, then press the [0(SET)] key to enter the Set mode.
3.
Rotate the DIAL knob to select the Set Mode Item 28: NAME.
4.
Press the [F/W] key momentarily to enable adjustment of this Item's setting.
5.
Rotate the DIAL knob to set this Set Mode Item to "FREQ" (enabling the frequency
display).
6.
Press the PTT key to save the new setting and activate the alpha-numeric Tag.
To display the alpha-numeric Tag again, just repeat the above procedure, rotating the DIAL
knob to select "ALPFA" in step 5 above.
R. F. Says: Set Mode Item 28:NAME is not applied to all memory channels at once (just the
channel on which you currently are operating).
Memory Offset Tuning
Once you have recalled a particular memory channel, you may easily tune off that channel,
as though you were in the "VFO" mode.
1.
With the VX-120/170 in the "MR" (Memory Recall) mode, select the desired memory
channel.
2.
Press the [MR(SKIP)] key momentarily to activate the "Memory Tuning" feature. The
Memory Channel number will be replaced by "tun." And if you have an alpha-numeric
Tag displayed on the memory channel, the display will automatically revert to display of
the operating frequency, so you can navigate without having to enter the Menu to
change the display configuration.
3.
Rotate the DIAL knob, as desired, to tune to a new frequency. The synthesizer steps
selected for VFO operation on the current band will be the steps used during Memory
Tuning.
VX-120/170 O
25/64
FCC ID: K6620223X20
IC ID: 511B-20223X20
M
PERATING
ANUAL
Vertex Standard Co., Ltd.
Advertisement
