NEC Univerge SV8100 VM8000 InMail System Manual page 304

Issue 1.0
3 - 18
47-01-08 Delay in Dialing Digital Pager Callback Number (Pager Dial Delay)
Use this option to set the delay (0~99 seconds) that occurs just before
VM8000 InMail dials the Digital Pager Callback Number portion of the
Message Notification callout number for a digital pager. Set this delay so
the pager service has enough time to connect to the digital pager before
sending the callback number. Your pager service may be able to help you
determine the best value for this option (0~99 seconds). By default, this
option is 9 seconds. When placing a digital pager notification, the system:
1. Seizes the trunk specified.
2. Dials user-entered notification number (in Message + OP + N).
3. Waits the 47-01-08 Delay in Dialing Digital Pager Callback
Number interval.
4. Dials number entered in 47-01-07 Digital Pager Callback
Number.
The system assumes that the notification number completes dialing
approximately 4 seconds after trunk seizure. This means that, by default,
the Digital Pager Callback Number is dialed to the pager service about 13
seconds after trunk seizure.
See Message Notification on page 2-173

Options
0~99 seconds
Default
9 seconds
47-01-09 Wait Between Digital Pager Callout Attempts (Notify Pager Intvl)
Use this option to set the minimum time (1~255 minutes) between
unacknowledged or unanswered digital pager Message Notification
callouts. (A subscriber acknowledges a digital pager notification by logging
onto their mailbox.) After this interval expires, VM8000 InMail tries the
callout again (for up to the number of times set in 47-01-14 Number of
Callout Attempts).
If the system dials the callout number and the pager service is busy, it will
retry the number in one minute.
See Message Notification on page 2-173

Options
1~255 minutes
Default
15 minutes
for more.
for more.
Programming
VM8000