NEC Univerge SV8100 VM8000 InMail System Manual page 27

VM8000
InMail System Guide
Allow the extension to switch the system night mode.
1. In 20-07-01 Manual Night Mode Switching, enter
switching in the extension Class of Service.
By default, this capability is disabled.

2. In 20-06-01 Class of Service for Extensions, assign the extension Class
of Service.
By default, extension 101 has Class of Service 15. All other extensions have

Class of Service 1.
Set up a Group Mailbox as a Call Routing Mailbox.
1. In 11-07-01 Department Group Pilot Numbers, assign a pilot number
(e.g., 200) to an unused Department Group (e.g., group 10).
By default, all extensions are assigned to group 1.

2. In 47-03-02 Group Mailbox Number, enter the pilot number assigned in
step 1 above.
By default, there are no Group Mailbox numbers assigned.

3. In 47-03-03 Group Mailbox Type, enter
a Call Routing Mailbox.
By default, Group Mailboxes are assigned as Subscriber Mailboxes (3).

4. In 11-07-01 Department Group Pilot Numbers, press Hold to remove the
assignment made in step
You can use the Department Group for other programming.

Set up a virtual extension that will handle the switching for the trunk.
1. In 11-04-01 Virtual Extension Numbering, assign the Group Mailbox
Number in step
For example, assign extension 200 to virtual extension port 1.

By default, there are no virtual extension numbers assigned.

Terminate the trunk to the virtual extension in the night mode.
1. In 22-07-01 DIL Assignment, assign the trunk to the virtual extension
(e.g., 200) in night mode 2.
When the extension user presses the night key, the trunk follows this routing.

By default, there are no DIL assignments set up.

2. Check the setting of 22-02-01 Incoming Call Trunk Setup to be sure the
trunk is set up as a Direct Inward Line (
 By default, trunk types are set to normal (0).
1 above.
2 as the extension number for a virtual extension port.
to enable night mode
1
to assign the Group Mailbox as
1
).
4
Issue 1.0
1 - 13