Sony HDCU3100 Operating Instructions Manual page 41

NETWORK
Page name Item
Page No.
<CNS SETTINGS> CNS MODE
N02
MCS MODE
CCU NO
MASTER IP
ADDRESS
SET
<NETWORK GENLOCK> PORT
N03
NETWORK
GENLOCK
Displayed only when
HKCU-SFP30 is installed.
PROFILE
PTP MASTER INFO
LOCK STATUS
Set value
LEGACY, BRIDGE, MCS
CLIENT
When MCS is selected in CNS
MODE: Blank, 1 to 96
When LEGACY or BRIDGE is
selected in CNS MODE: Blank, 1
to 96, A to Z
0.0.0.0 to 255.255.255.255
LAN1, LAN2
DISABLE, ENABLE
ST2059-2
DOMAIN 0 to 127, 127
NUMBER
COMMUNICATION MULTICAST MODE,
MODE MIXED MODE
DELAY –7 to –1, –3
REQUEST
INTERVAL
IP ADDRESS 0.0.0.0 to 255.255.255.255
SYNC INTERVAL –7 to –1, –3
PRIORITY 1 0 to 255, 128
PRIORITY 2 0 to 255, 128
STEP ONE-STEP, TWO-STEP
NOT IN USE, NO MASTER,
LOCKING, LOCKED
Description
Sets the communication mode.
Indicates that the unit is the client when MCS mode
is selected. (Display only)
Sets the CCU number.
Sets the master device IP address for MCS mode.
A "SET OK?" message is displayed. Press ENTER
again to confirm the change. (Execute via ENTER.)
Selects the port to use.
Enables/disables network genlock.
Displays the supported profile.
Only the ST2059-2 profile is supported.
Sets the domain number.
Note
Set to the domain number of the connected master
device.
MIXED MODE: Unicast communication with master
MULTICAST MODE: Multicast communication with
master
Displays the response rate to the PTP master.
Displays values acquired from the PTP master.
Displays the IP address of the currently locked PTP
master device.
Displays the Sync Interval setting of the master
device.
Displays the priority level of the PTP master.
The lower the value, the higher the priority.
Displays the mode in which timestamps are sent.
ONE-STEP: Sent in Sync packet
TWO-STEP: Sent in Follow-up packet
Displays the genlock operation status.
NOT IN USE: PTP operation stopped
NO MASTER: PTP master not available
LOCKING: Locking in progress
LOCKED: Locking completed
41