Sony HDCU3100 Operating Instructions Manual page 22

SYSTEM CONFIG
Page name Item
Page No.
<VIDEO I/O> SDI-I/O 1
S02
SDI-I/O 2
SDI-I/O 3
SDI-I/O 4
<REAR I/F> CHARACTER/AES-
EBU
S03
PROMPTER2/VBS-
RET
MIC/WF REMOTE
REAR PREVIEW
Set value
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
(SDI-OUT)
When IN is selected in I/O:
(SDI-RET)
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
(SDI-OUT)
When IN is selected in I/O:
(SDI-RET)
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
SDI-OUT, HD TRUNK
When IN is selected in I/O:
(SDI-RET)
I/O IN, OUT
SIGNAL When OUT is selected in I/O:
(SDI-OUT)
When IN is selected in I/O:
SDI-RET, HD PROMPTER
CHARACTER, AES-EBU
ENABLE, DISABLE
MIC REMOTE, WF REMOTE
MOMENTARY, TOGGLE
Description
Sets SDI I/O 1.
Selects input or output.
Sets the signal function.
Sets SDI I/O 2.
Selects input or output.
Sets the signal function.
Sets SDI I/O 3.
Selects input or output.
Sets the signal function.
a)
Sets SDI I/O 4.
Sets the signal function.
a)
Sets the function to assign to the CHARACTER/
AES-EBU connector.
CHARACTER: Set to VBS output on which
character superposition is performed.
AES-EBU: Set to AES-EBU output.
Sets the function to assign to the PROMPTER2/
VBS-RET connector.
ENABLE: Set to both signal input for the second
tele-prompter and VBS return signal input. (VBS
return signal only when using HDCU3170)
DISABLE: The PROMPTER1 input signal is output
as is (loop-through output).
If loop-through output is not used, terminate the
connector at 75 ohms.
Switches the function of pins 36 to 43 when a D-sub
50-pin board is mounted as the INTERCOM/TALLY/
IO PORT connector.
Sets the operation mode of the REAR PREVIEW
connector output.
22