Sony HDCU3100 Operating Instructions Manual page 23

SYSTEM CONFIG
Page name Item
Page No.
<GENLOCK> REFERENCE
S04
LOCK STATUS
GENLOCK MODE
H-PHASE STEP
H-PHASE COARSE
V-PHASE
SYNC OUT SELECT
Set value
NOT DETECTED, EXT IN, 1080/
59.94I, 1080/23.98PsF, 720/
59.94P, 1080/50I, 1080/24PsF,
720/50P
When HD or SD is selected in
GENLOCK MODE:
LOCKED, NOT LOCKED
HD, SD, NETWORK
10F BB OFF, ON
When HD is selected in GENLOCK
MODE:
–3.01 to 3.45 µsec 0.00
When SD is selected in GENLOCK
MODE:
–8.29 to 9.48 µsec 0.00
–99 to 99, 0
0 to 7
SD SYNC, HD SYNC
Description
Signal input of the REFERENCE IN connector.
(Display only)
Lock status of the external reference signal. (Display
only)
Sets the lock mode of the external reference signal.
Notes
• NETWORK is displayed only when the HKCU-
SFP30 ST-2110 Interface Kit is installed.
• Set to NETWORK if operating within an SMPTE
ST 2110 compliant system.
• When set to NETWORK, an external reference
input on the REFERENCE IN connector is not
required, and network synchronization operates
using the LAN-1 and LAN-2 connectors. The
network synchronization setting is configured on
the <NETWORK GENLOCK> page of the
NETWORK menu.
Sets whether to use the 10-field ID added to the
external reference signal.
This can be selected when GENLOCK MODE is SD
and <MULTI FORMAT> page t SYSTEM is 1.001
(525).
Adjusts the horizontal lock phase in relation to the
reference signal (steps).
Adjusts the horizontal lock phase in relation to the
reference signal (fine adjustment).
Adjusts the vertical lock phase in relation to the
reference signal (line).
Sets the output signal of the REFERENCE OUT
connector.
23