Special Recording 0; Pre Rec 0 - JVC Connected Cam GY-HC900CHU Instructions Manual

Special Recording 0

Besides the normal recording mode, four special
recording methods are available in this camera
recorder. They are Pre Rec, Clip Continuous,
Frame Rec and Interval Rec.
Select a mode from [System] B [Record Set] B
[Rec Mode].
(A P154 [ Rec Mode 0 1 ] )
Memo :
Special recording cannot be selected when
0
[System] B [Record Set] B [Record Format] B
[System] is set to "HD+Web"2 or "High-
Speed"2.

Pre Rec 0

By setting the number of seconds in the [Pre Rec
0
Time], you can start recording video and audio
before actual recording starts based on the [Pre
Rec Time] setting.
When starting actual recording while the camera
0
recorder is in Recording Standby (STBYP)
mode, you can start recording a few seconds
earlier based on the [Pre Rec Time] setting.
Using Pre Rec allows you to record a complete
0
event without missing the initial scenes even if
you start the recording late.
Memo :
Pre Rec Time can be set in [System] B [Record
0
Set] B [Rec Mode] B [Pre Rec Time].
90
Special Recording 0
Completed Clip
(Recorded video and audio)
Recording starts a
number of seconds
earlier based on the
[Pre Rec Time] setting
Press [REC]
(Recording starts)
.
1 Set [Rec Mode] to "Pre Rec".
(A P154 [ Rec Mode 0 1 ] )
Set [System] B [Record Set] B [Rec Mode]
0
to "Pre Rec".
The display changes ("STBY" B "STBYP").
0
2 Press the [REC] button to start recording in
Pre Rec mode.
The display changes ("STBYP" B
0
"RRECP") and the card slot status indicator
lights up in red.
Press the [REC] button again to pause
0
recording. The display changes ("RRECP"
B "STBYP") and the card slot status
indicator lights up in green.
Caution :
When the interval between start and stop
0
recording is short, "STBYP" may not be
displayed immediately after recording is
complete.
"RRECP" B "STBYP" ("STBY" blinks in red) B
"STBYP" is displayed.
When the SD card becomes full during
0
recording, recording stops and "STOP" is
displayed.
In the following cases, video and audio before
0
the specified Pre Rec time may not be recorded
even if recording starts.
Immediately after power on
0
Immediately after recording stops
0
Immediately after switching from Media
0
mode to Camera mode
Immediately after setting [Rec Mode]
0
Immediately after the end of Clip Review
0
Immediately after changing file format
0
Immediately after changing video format
0
Press [REC]
(Recording stops)