Sony CCD TRV 10 E Operating Instructions Manual page 59

AC power adaptor
Symptom
The POWER lamp does not
light.
The CHARGE lamp flashes.
When the CHARGE lamp flashes
Check through the following chart.
Remove the battery pack from the
AC power adaptor. Then install the
same battery pack again.
When the CHARGE lamp flashes
again
Install another battery pack.
When the CHARGE lamp flashes
again
The problem is with the AC power
adaptor.
Please contact our nearest Sony
dealer in connection with the
product with the problem.
If you use a battery pack which you have just bought or which has been left unused for a long
time, the CHARGE lamp may flash at the first charging. This does not indicate a problem. Repeat
again to charge with the same battery pack.
Cause and/or Corrective Actions
• Set the selector to VTR (DC OUT) and disconnect the
mains lead. After about one minute, try again. (p.9)
• See the following chart.
$
$
$
$
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, there is no
problem.*
$
When the CHARGE lamp does not
flash again
If the CHARGE lamp lights up and
goes out after a while, the problem is
with the battery pack installed first.
59