To Disconnect The Preprocessor Interface From The Probe Adapter; Power Requirements; Replaceable Parts - HP E2494A Installation Manual

To disconnect the preprocessor interface from the probe adapter

To disconnect the preprocessor interface from the
probe adapter
The Mictor connectors can be damaged by excessive stress. Always
disconnect using the reverse procedure as connecting. Disconnect the
assembly from the target system, then the probe adapter from the
instrumented board, then the preprocessor interface cables from the probe
adapter.
To protect your equipment, remove the power from both the HP E2487A
C A U T I O N
Preprocessor Interface and the target system before you make or break
connections.

Power requirements

The probe adapter draws a maximum 100 mA @ 5V, which is supplied by the
logic analyzer.
CAT I, Pollution degree 2.
This product is intended for indoor use only.
Cleaning
Remove any dust or debris from the probe adapter with precision dusting
cleaner (otherwise known as inert dusting gas or compressed air).

Replaceable parts

The repair strategy for this probe is product replacement.
11