Table of Contents
Advertisement
To connect to the target system
Plug the probe adapter into the 190-pin Mictor connector on the
3
Pentium II Instrumented Mobile Module, ensuring that Pin 1 is
properly aligned (see illustration below).
Damage to the connectors on the target system and probe adapter can result
C A U T I O N
from incorrect connection. Note the position of Pin 1 of the 190-pin Mictor
connectors on the probe adapter and the Instrumented Mobile Module board
prior to making any connection. Take care to align the probe adapter
connector with the pins on the Instrumented Mobile Module board
connector so that all pins are making contact. Also, ensure that the probe
adapter is firmly seated in the 190-pin Mictor connector, and that the probe
adapter is parallel within ±4° with the Pentium II Instrumented Mobile
Module.
Connecting the probe adapter to the Pentium II Instrumented Mobile Module board
Loosen the adjustment screws to ensure that there will be adequate
4
clearance once you connect the assembly to the target system.
6
Advertisement
Table of Contents
