Wall Mount Adapter Operation - Motorola G24 Developer's Manual

Wall Mount Adapter Operation

To Use a Wall Mount Adapter
1. Connect the Wall mount adapter to the Power Adapter connector (J210)
2. Verify that jumper P203 is connected and jumper P204 is disconnected (default setup).
Important:
Adapter Connector
Figure 2-8: G24 Developer's Kit Wall Mount Adapter Connector
The Wall Mount Adapter connector is located at the rear of the Developer Board,
immediately to the left of the Power On/Off switch.
The Wall Mount Adapter connector pinout is described in
constant 4.5 V, which is regulated to a nominal 4.1 V on the Developer Board.
Important:
April 1, 2006
Verify that the Wall mount adapter is not connected to the USB connector (J380).
Power
Indicator LED
Wall-mount
Power
On/Off Switch
Table 2-1: Wall Mount Adapter Connector Pinout (J210)
The G24 includes an on-board protection circuit for cases in which the USB
connector is connected by mistake to the Wall Mount Adapter connector (J210).
If by mistake, the Mini AB USB cable is connected to J210 instead of J380, the on
board Wall mount adapter is disabled, preventing unrequired load on the host
computer.
Developer's Kit
Chapter 2: Developer Board and Interfaces Description
Table
Pin # Pin Name
1
GND
2
Not connected
3 Not connected
5 Detection circuit
6 VCC
(Figure 2-8)
2-1. The adapter supplies a
13