Anti-Tip Device; Secure Refrigerator To Cabinetry - GE Monogram ZIPS360NHSS Technical Service Manual

Anti-Tip Device

WARNING
These refrigerators are top heavy, especially with
any doors open, and must be secured to prevent
tipping forward which could result in death or
serious injury.
IMPORTANT: When the refrigerator is installed
for this method of security using the anti-tip wall
bracket, proceed to the Level Refrigerator section
for leveling instructions, and then to the Secure
Refrigerator To Cabinetry section to secure the
refrigerator to the cabinets.
The refrigerator MUST be secured to prevent tipping.
1. The "L" rod can be found in the upper left corner
of the unit in the access compartment. Look
through the access compartment to make sure
the rod lines up with the anti-tip bracket.
2. There are two washers and a hair pin cotter with
the rod. Remove the washers and hair pin cotter
from the end of the rod.
3. Rotate and move the "L" rod into the slot in the
anti-tip bracket tab. Once it is in the slot, rotate
the "L" rod so the hook portion is pointing down.
The holes at the front end of the rod should be in
a vertical position.
'L' Rod Pointing Down
Engaged in Bracket
4. Pull out on the end of the rod to make sure it is
secure in the bracket.
5. Locate the hole on the rod that is closest to the
unit. A hair pin cotter will be put through this
hole to secure the rod. If this hole appears to be
tightly into the hole.
Tip Over Hazard!
– 12 –
6. Align the straight section of the pin with the hole
from the underside of the rod. Push the pin up
until it snaps into position. Pliers may be used.
NOTE: The hair pin cotter must be vertical when
this step is completed to ensure the "L" rod is
engaged in the bracket.
7. Check the rod for tightness by pulling forward. If
the rod moves, remove the hair pin cotter and
place another washer on the rod. Reinsert the
pin.
'L' Rod Pointing Down
Engaged in Bracket
Hair Pin Cotter
is Vertical

Secure Refrigerator to Cabinetry

Whenever possible, perform these steps in addition
to the Anti-Tip Device procedures for anti-tip
security. The refrigerator must be secured to
prevent tipping.
1. Raise the grille panel to access the case trim.
2. Drill a hole in the trim and drive a screw through
the trim into the adjacent cabinet.
3. Follow the same procedure on the opposite side.
Drive Screws Through Case Trip and Into Adjacent
Cabinets
Washer
Washer