System Control Instructions; Starting The Ups System In Double Conversion Mode - Eaton 93PR Series User And Installation Manual

Hide thumbs Also See for 93PR Series:

Table of Contents

6.4

System Control Instructions

6.4.1

The UPS system can consist of a single UPS or several parallel UPSs. UPSs with their MOB open are not

considered as part of the system.

To start the UPS system:

1. Unfasten the front door latch and swing the door open.

2.Verify that rectifier input switches, bypass input switch, neutral switch are closed if included inside the UPS

system, and verify that battery breaker is closed.

3. Close the UPS input feeder circuit breaker.

4. Close the UPS bypass input feeder circuit breaker.

5. Observe the UPS control panel display becoming active, indicating logic power. Repeat steps 1-5 for each

individual UPS in the system.

6. Press the Controls button in the main menu. The System Controls screen appears.

7 . On the System Controls screen, the system status should indicate SHUTDOWN.

8. Press the Go online button on the System Controls screen. If Auto Bypass is enabled (factory default), the

critical load is immediately supplied by the bypass source, in Bypass Mode, until the inverter turns on and the

UPS transfers to Double Conversion Mode. The status indicator on the UPS control panel indicates the UPS

is in Bypass Mode. If auto bypass is not enabled, the UPS output remains off until the UPS system transfers

to Double Conversion Mode.

9. Observe the following messages appear sequentially on the System Controls screen:

The rectifier and inverter turn on. The DC voltage continues to ramp up to full voltage. Once the DC link

reaches full voltage, and the battery breaker is closed, the UPS output relay K3 closes and the static switch

turns off. Power is now supplied to the Critical load in Double Conversion Mode. It takes approximately 20

seconds for the UPS system to achieve Double Conversion Mode.

10. The UPS system is now operating in Double Conversion Mode and the NORMAL status indicator is

illuminated in all UPSs in the system.

STARTING

ONLINE

User's and Installation Guide

25-75 kW

Table of Contents

93pr 50(75)93pr 75(75)93pr 25(75)