Commissioning and diagnostics in the Web server
6.6 Settings
6.6
Settings
6.6.1
Setting limits
When required, you can configure limits for elements of your converter and adapt to the
requirements of your mechanical system in the "Parameters - Limits" view.
Figure 6-11
Setting limits
1. Select "Parameters" and "Limits" in the navigation.
The table below the graphic shows the "Maximum speed" line of the speed limitation.
2. Enter the maximum speed in the input field of the same name.
3. Enter the two torque limit values.
– "Torque limit when motoring"
– "Torque limit when generating"
4. Click
124
Parameters - Limits
to save the data permanently.
SINAMICS S210 servo drive system
Operating Instructions, 12/2017, A5E41702836B AA