Table of Contents
Advertisement
3.4.1
Sensors menu
[HDG] page (Local Sensor)
[SPD] page (System Sensor)
Vector defined by (SOG and COG) is equal to vector sum of vectors defined by (SPD
and HDG) and (set and drift).
[Sensors]: Select the heading sensor to use.
[Analog Gyro]: No use.
[Manual]: Set heading manually when there is no head-
ing sensor available.
[Gyro Correction]: Set correction manually for the head-
ing value. (Not available with the [System Sensor Set-
ting] menu.)
[Stabilization Mode]: Select the water stabilization
mode: Select [Bottom] for ground stabilization, or select
[Water] for sea stabilization.
[Sensor Type]: Select [GPS] in case of a GPS naviga-
tor, or [LOG] for speed log.
[Data Source]: Check [Sensors] to use a sensor in the
[Sensors] list, or click [Manual] to enter speed manually.
Use [Manual] when no speed source is available.
[Manual]: Input speed manually. Check [Water] in [Sta-
bilization Mode] and deactivate the AIS function to en-
able entry.
[Reference SPD]: Check to use radar as the source for
speed and course. (Only available with the Local Sen-
sor Setting and checking [Bottom] in [Stabilization
Mode].)
[Set Drift]: Check the [Set Drift] checkbox to manually
set speed and course of drift. Note that you can select
manual drift only if you check [Water] in [Stabilization
Mode].
Angle = Difference between heading and COG
Spd = Speed component of the drift vector
Cse = Course component of the drift vector
3. SETTINGS AND ADJUSTMENTS
3-5
Advertisement
Table of Contents
