Table of Contents
Advertisement
2.2.4
Flexible waveguide
The connector at the antenna side is preattached to the flexible waveguide. The bend-
ing radius shown below must be observed to prevent damage to the waveguide.
E-bend: 200 mm, H-bend: 400 mm
2.3
How to Connect Cables
2.3.1
How to connect the antenna cable, serial cable, and LAN cable
1. Remove the cover of the unit.
2. Lay the cables in respective cable slots so their armors rest in the slots.
3. Connect the power line of the serial cable to the RF-TB Board as shown in the fig-
ure below.
Serial cable
Antenna cable
Antenna cable: TB803
●
Serial cable: TB803
●
How to connect wires to WAGO connector
Wire
Antenna cable
Press downward.
<Procedure>
Terminal
1. Twist the cores.
opener
2. Press the terminal opener downward.
3. Insert the wire to hole.
4. Remove the terminal opener.
WAGO
5. Pull the wire to confirm that it is secure.
connector
Twist
Serial cable
Insertion
point
Clamp
TB803
TB801
2. WIRING
LAN cable
2-3
Advertisement
Table of Contents
