Graco 1095 Operation, Parts page 46
Electric airless sprayers, for professional use only, not approved for use in explosive atmospheres or hazardous locations, for portable airless spraying of architectural paints and coatings, 3300 psi 228 bar, 22.8 mpa maximum working pressure
Hide thumbs
Also See for 1095:
- Operation manual (21 pages) ,
- Operation, parts (88 pages) ,
- Parts manual (19 pages)
Table of Contents
Advertisement
Troubleshooting
Electrical cont...
Sprayer does not run at all, display is
blank, or BlueLink status light never lights
up.
(See following page for steps)
Remove control box cover. Turn
sprayer ON. Observe control
board status light on control board
(see below).
No light
Once
Normal
operation
Light on
Control board
Continuously
commanding
motor to run
Flashing
See Code
section for
further
troubleshooting
See step 3. Does
potentiometer.
46
See step 2. Is the
proper reading
present through the
thermal switch
wires?
YES
the motor run?
YES
Replace
See step 1. Do
you have over
100 VAC
(220 VAC for
230V units)?
YES
NO
Connect a test
transducer to the
NO
board. Does the
YES
Replace the
transducer
Repair or
NO
replace
power cord.
If motor is hot, let cool
and retest. If step 2 still
shows incorrect
resistance, replace
motor. The motor has
a defective thermal
device.
motor run?
Replace the
control board.
NO
3A6342A
Hide quick links:
Advertisement
Table of Contents
