Graco ULTRA MAX II 695 Quick Operator's Manual

ULTRA
MARK V
Quick Operator's Guide
WARNING
SETUP
Connect hose to sprayer and gun.
Tighten hose connections with wrench.
Place siphon tube in pail
Turn prime valve
partially filled with water.
to Prime position (down).
Aim gun at inside
Make sure safety wall of water pail
lever of gun is OFF. and squeeze trigger.
Increase pressure until
Keeping gun triggered into
sprayer starts and paint water pail, turn prime valve
comes out of drain tube.
to Spray position (horizontal).
CHOOSE THE RIGHT TIP (286-XXX) & FILTER
109 111 113 115
207 209 211 213 215 217 219 221 223 225
307 309 311 313 315 317 319 321 323 325 327
409 411 413 415 417 419 421 423 425 427
509 511 513 515 517 519 521 523 525 527
609 611 613 615 617 619 621 623 625 627
.20 .33 .49 .69 .91 1.17 1.47 2.15 2.54 2.96 3.42
Flow Rate (l/min.)
200 100
Pump Filter (mesh) (orange) (blue)
100 100
Gun Filter (mesh) (orange) (orange)
www.graco.be
GRACO N.V. • Industrieterrein Oude Bunders • Slakweidestraat 31 • B-3630 Maasmechelen
Tel. (32) 89 770 700 • Fax (32) 89 770 777 • E-mail: info@graco.be
MAX II 695/795/1095
®
™ - MARK X
This procedure is for water-base paints and flushing fluids. For solvent-base paints and flushing
fluids (i.e. mineral spirits), you must read Fire and Explosion Hazard in the Operating Instructions.
* check the Graco operations manual delive red with the unit for more deta i l s.
Unscrew tip & guard from gun.
Turn pressure control knob
to lowest pressure, and set
power switch to ON.
Increase pressure
until sprayer starts.
Keep gun triggered into
water pail for 1 minute.
Release trigger.
When paint comes out of gun,
release trigger and turn safety
lever of gun to ON.
119 121
721 723 725
815 817 819 821 827
917
60 30
(black) (grey)
60
(blue)
™
Fill throat packing nut with TSL ™
to prevent premature packing wear.
Increase pressure until
sprayer starts and water
runs out of prime tube.
Let water run out of
prime tube for 15 seconds.
Turn prime Place siphon tube in paint
pail, but leave drain tube
valve to Prime
position (down). in water pail.
Transfer drain
tube to paint pail.
235
331
429 433 435 439 443
529 531 533 543
629 631 633 635
729 735
831 833 835
935
3.90 4.42 4.98 6.18 7.51 8.23 10.5712.99
none
none
Make sure power Plug electrical cord
switch is set to OFF. into grounded outlet.
Turn prime valve
Decrease pressure to Spray position
until sprayer stops. (horizontal).
Aim gun at inside
wall of water pail,
and squeeze trigger.
Screw tip & guard onto gun, making sure
arrow-shaped handle of tip is pointing forward.
You can reverse this tip to quickly clear clogs
without taking it apart.
5 cm
10 cm
15 cm
451 455 20 cm
551 555 25 cm
645 655 30 cm
35 cm
40 cm
45 cm