Graco 1095 Operation, Parts page 42
Electric airless sprayers, for professional use only, not approved for use in explosive atmospheres or hazardous locations, for portable airless spraying of architectural paints and coatings, 3300 psi 228 bar, 22.8 mpa maximum working pressure
Hide thumbs
Also See for 1095:
- Operation manual (21 pages) ,
- Operation, parts (88 pages) ,
- Parts manual (19 pages)
Table of Contents
Advertisement
Troubleshooting
Problem
•
Sprayer does not run at all
•
Display shows CODE 05
•
BlueLink status light blinks 5
times repeatedly
42
Cause
Control is
7.
commanding
motor to run but
motor shaft
does not rotate.
8.
Solution
Perform Field Short Test: Test
at large 4-pin motor field connec-
tor. There should not be continu-
ity from pin 4, the ground wire,
and any of the remaining 3 pins.
If motor field connector tests fail,
replace motor.
Check Motor Thermal Switch:
Unplug thermal wires. Set meter
to ohms. Meter should read the
proper resistance for each unit
(see table below).
-
ti13140a
Resistance Table:
695/240V Mark IV
795/120V Mark IV
1095/230V Mark V
1595/120V Mark
V/Mark VII
Mark X
0 ohms
2k ohms
3.9k ohms
6.2k ohms
10.0k ohms
3A6342A
Hide quick links:
Advertisement
Table of Contents
