Installing An Internal 3½-Inch Device (Short Tower Computers) - DEC Digital PC 3500 System Reference Manual

Adding Mass Storage Devices
Installing an Internal 3½-Inch Device (Short Tower Computers)
The following procedures describe how to install a low profile, 1-inch high,
3½-inch mass storage device into the internal device bay.
NOTE
storage device to determine if switches or jumper settings need to
be set or installed on the device. Set all switch or jumper settings
accordingly.
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover.
4. Disconnect the data and power cables from the installed hard disk drive.
Refer to "Connecting Diskette and IDE Devices (Short Tower Computers)" later in this
chapter.
5. Remove the two screws securing the device bay to the chassis.
6. Swing the device bay away from the chassis to gain access to the upper
bay.
6-22
: Refer to the manufacturer's instructions for your mass