Adding Mass Storage Devices
Installing a 3½-Inch Device (Short Tower Computers)
The following procedures describe how to install 3½-inch device into a front-access
device bay.
NOTE
determine if switches or jumper settings need to be set or installed
on the device. Set all switch and jumper settings accordingly.
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover.
4. Remove the front bezel (see Figure 6-8).
5. Remove the EMI shield filler plate and drive rail.
6. Install the brackets and drive rail onto the 3½-inch device
(see Figure 6-2).
7. Carefully slide the 3½-inch device into the device bay.
Secure the device using the supplied mounting screws.
8. Connect the power and data cables to the 3½-inch device.
Refer to "Connecting Diskette and IDE Devices (Short Tower Computers)" later in this
chapter.
6-18
: Refer to the manufacturer's instructions for your device to