Adding Mass Storage Devices
Installing a 5¼-Inch Device (Low Profile Computers)
The following procedures describe how to install a 5¼-inch device into the bottom-
right device bay.
NOTE
determine if switches or jumper settings need to be set or installed
on the device. Set all switch and jumper settings accordingly.
1. Turn off your computer and monitor.
2. Disconnect all external devices, ac power, and monitor power.
3. Remove the outside cover.
4. If necessary, remove the filler panel from the front bezel.
5. Remove the EMI shield filler plate and the drive rail from the inside of the
chassis.
6. Attach the drive rail onto the 5¼-inch device.
7. Using the attached drive rail and mounting screws, install the 5¼-inch device
into the device bay.
8. If necessary, replace the filler panel.
9. Connect the power and data cables to the 5¼-inch device.
Refer to "Connecting Diskette and IDE Devices (Low Profile Computers)" later in this
chapter.
6-8
: Refer to the manufacturer's instructions for your device to