ActionTec GT701 User Manual page 41

Actiontec USB/Ethernet DSL Modem User Manual
Specify a Static IP Address
Select this option if the
Routed using a static
Modem Address provided by the
Address" screen, which causes the
IP
nate at the Modem, as opposed to the
bridged to terminate at the computer. This allows the use of the router capabilities
for the Local Area Network (
☞
Note: Contact the
Encapsulation
If the Modem is configured to obtain an
static address, select the appropriate encapsulation option used by the ISP (
IP
Bridged or
1483 RFC 1483
☞
Note: Contact the
Unnumbered Mode/VIP Mode
If a block of public static
Unnumbered Mode by clicking in the appropriate check box. Then, enter the IP
Address and Subnet Mask in the "Modem Address" and "Unnumbered Subnet
Mask" text boxes below the "Unnumbered
and Restart to make all changes permanent.
service is configured to use
ISP
Address. Enter the
IP
in the "Broadband Connection via Static
ISP
IP
IP
).
LAN
if unsure of the proper configuration.
ISP
Routed).
if unsure of the proper configuration.
ISP
addresses was purchased from the
IP
RFC 1483
Address, Subnet Mask, and Default
IP
address and routing information to termi-
address and routing information being
address through
IP
Address." Click Next, then click Save
IP
38
Bridged or
or to specify a
DHCP
RFC
, select
ISP