Dorel Juvenile Group Scenera Instructions Manual page 8

4358-5405 Can Scenera 12/8/10
C-2 Preparing Restraint System to Fit
Your Child
You MUST make these adjustments with your child before you
install the restraint system in the vehicle.
1.
2.
3.
4.
13
2:50 PM Page 15
Loosen Harness Straps
Push in on the harness
adjustment lever under the
flap. Pull out on harness
straps just above buckle
tongues.
Release Chest Clip
Press on chest clip release
button and pull apart.
Unbuckle Harness Straps
Press down on the red
buckle release button to
release the buckle tongues.
Place harness straps over
sides of restraint system.
Place Child in Restraint
System
Place the child's bottom and
back flat against the restraint
system. This will increase
comfort and allow the
harness straps to be properly
tightened.
5.
Check Buckle
Position
Determine which of the three
buckle/crotch strap slots that is
1
both comfortable and snug to
2
use.
3
Note:
strap through the slot closest to
child.
You MUST use the 1st or 2nd buckle/crotch strap
slots when rear-facing. Any slot can be used for
forward-facing.
To Change Buckle
Position
a.
Turn the restraint system
over and locate the
buckle/crotch strap's
metal retainer.
b. Rotate buckle/crotch
strap's metal retainer,
then insert retainer up
through the shell and pad.
c.
From the front, pull
buckle/crotch strap free
from shell and pad.
14
Thread buckle/crotch
continued on next page.