Table of Contents
Advertisement
4358-5405 Can Scenera
12/8/10
• Switchable retractor
These belts switch from ELR to ALR (Automatic Locking
Retractor). You must have the vehicle belts in the locking
mode to use them. Follow the instructions in the
installation sections.
• ALR (Automatic Locking Retractor)
These belts lock after pulling the webbing out and letting the
belt go back into the retractor an inch or two. Follow the
instructions in the installation sections.
Vehicle Latch Plates
Locking
Latch
Plate
Sliding
Latch
Plate
plate. If you have an ELR retractor and a sliding latch plate, you
MUST use a locking clip to install the restraint system or move
to another seating location. You may not need to use the
locking clip with a switchable or ALR retractor. Consult your
vehicle owner's manual.
D-5 Using the Locking Clip
A locking clip is used to prevent the vehicle belt from
loosening before a sudden stop or crash. The locking clip can
only be used on a lap and shoulder belt combination. The
locking clip is located on the back of the restraint system.
locking clip will not fix all types of vehicle seat belt
problems.
Review section D-4 and your vehicle's owner manual for
vehicle seat belt use with restraint systems to see if a
locking clip is needed.
37
2:50 PM
Page 39
• Check the Latch Plates
Buckle the lap/shoulder belt.
Pull on the lap belt portion. If
the vehicle belt does not
loosen or slip, you have a
locking latch plate. You
should not need to use a
locking clip. Consult your
vehicle owner's manual.
If the belt loosens or slips,
you have a sliding latch
A
The following directions describe installing the infant restraint
rear-facing. Same steps apply for forward-facing, except
install the restraint forward-facing and thread the vehicle belt
in the forward-facing belt path.
Do not use both the UAS belt and vehicle belt at
the same time.
When rear-facing, use only in the recline
position. Do not use the recline stand.
When forward-facing, use only the upright
position. Do not use the recline position.
1.
Secure UAS Belts
You MUST attach the UAS
belt hooks to the side of
shell as shown when using
the vehicle seat belts.
2.
Fold the recline stand
under the Infant
restraint
2
1
3.
Secure Tether Hook
Attach the tether hook to
the recline stand as
shown. Tighten tether to
remove the slack.
38
continued on next page.
Advertisement
Table of Contents
