Canon iR C6800 Series Installation Procedure page 42

Chapter 1
registration (left/right margin) by 1.0 mm.
6) Tighten the 2 screws you loosened in step 3).
7) Close the right deck.
- Manual Feed Tray
1) Loosen the 2 screws [1], and move the slide guide
[2] to adjust the horizontal registration.
[2]
[1]
F-1-120
2) Check to see that the horizontal registration (left/
right margin; L1) of the copy made on paper from the
manual feed tray is 2.5 +/-1.5 mm.
[1]
image
F-1-121
[1] Paper feed direction
3) Tighten the screws you loosened in step 1) to fix the
slide guide in place.
34
1.2.23
Adjusting
Leading
Registration
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
Adjust the leading edge registration as follows
according to the source of paper:
Check to be sure that the leading edge registration
(leading edge margin; L1) of the copy made on paper
from the cassettes and the deck is 4.0 +1.5/-1.0 mm.
If not, go through the following:
- Make the following selections in service mode:
COPIER>ADJUST>FEED-ADJ>REGIST.
- Then, change the setting to make adjustments.
(A change of '1' moves the leading edge registration
by 0.1 mm. A higher setting will move the image
toward the leading edge.)
L2
[1]
Image
F-1-122
[1] Paper feed direction
1.2.24 Securing
Machine in Place
iR C6800C / iR C6800CN / iR 5800C / iR 5800CN
1) If the machine is already at its site of installation,
secure it in place using the 2 adjusters.
2) Peel the double-sided tape from the back of the
service book case [1]; then, attach the case by
matching its right edge against the line marking [3]
found on the right side of the bottom plate [2] of the
machine.
the
Edge
0002-6735
the
0002-6736